Auto provisioning - Cisco PAP2 Adapter

Below you will find instructions how to auto configure Cisco PAP2 Adapter for use with VoIPstudio system.

If your phone was purchased from VoIPstudio, it has been already pre configured and there is no need to provision it. Please refer to Phone edit section to assign extensions. If your phone was not purchased from VoIPstudio, please perform a Factory Reset described in Factory Reset section above and Firmware upgrade.

You can obtain your phone IP by following the steps described in Find phone IP section above.

Add Phone to VoIP Studio Customer control Panel as Indicated below before Proceeding.

To add a phone purchased from the third party vendor:

1. Click Add button located in Phones panel.
2. Select your device model.
3. Enter your device MAC address - five groups of digits and letters separated by a colon sign for example: 00:1a:4d:5c:25:8d. Usually printed on the label located at the back of the device.
4. Name Device as required.
5. Click Add button.
6. Copy and Paste URL into Phone Configuration as shown below.

Once a supported devices is added to our system you can obtain auto-provisioning URL, enter it into device settings and manage the phone via your web based control panel.

To auto provision Cisco PAP2 login into web interface of the device and follow steps below:

1. Click Admin Login link at the top of the page.
2. Click Advanced link at the top right part of the page.
3. Select Provisioning tab at the top.
4. Make sure Provision Enable is set to Yes.
5. Make sure Resync On Reset is set to Yes.
6. Copy and paste your Profile URL (see (2) in Figure %IMG_PHONES_CISCO_RESET% above) into field (6).
7. Click Save Settings button.

After a short while your Cisco VoIP adapter will reboot and obtain configuration data from VoIPstudio provisioning service.